Traditional Culture Encyclopedia - Traditional festivals - Steps and Precautions for Floor Paving

Steps and Precautions for Floor Paving

The following tools and materials need to be prepared for flooring. * * * There are 9 steps and 4 precautions. This paper will introduce the steps and precautions of floor laying in detail to help readers better understand the floor laying method.

Prepare tools and materials

The following tools and materials need to be prepared for paving the wooden floor: saw or chainsaw, nail gun or nail, pencil, ruler, ground hammer, woodworking glue, wooden floor, floor mat and barbed wire.

Sweep the floor

Clean up the dust and sundries on the ground to ensure that the ground is flat, dry and free of sundries.

Positioning laying

According to the shape and size of the room, determine the laying direction and position of the floor, and mark the floor with a pencil.

take one's measurement

Measure the length and width of the room with a ruler, calculate the number of floors needed, and reserve about 10% for later use.

Cut the floor

According to the measured size, cut the floor into the required size with a saw or a chainsaw.

flooring

Spread the floor from one side of the room, stick the first floor to the ground with woodworking glue, and tap it gently with a floor hammer to ensure that the floor is flat and tight. Insert the next floor into the tenon of the first floor, and gently tap it with a floor hammer to ensure that the floor is flat and dense. Repeat the above steps to lay all floors.

Rough repair.

After laying, check whether the floor is flat and tight. If there is any unevenness, it can be repaired with woodworking glue or nails.

Matters needing attention

1. Before laying the floor, be sure to clean the floor to ensure that the floor is flat and dry without unevenness. 2. When laying the floor, pay attention to the direction and position of the floor to ensure that the floor of the whole room looks neat and beautiful. 3. When laying the floor, gently tap it with a floor hammer to ensure that the floor is flat and dense. 4. After the floor is laid, clean up the sawdust and dust on the ground in time to keep the ground clean and tidy.