Frank mask manual course

Frank Musk is a representative of a famous alien monster. The following is a tutorial of Frank's mask handcrafting, hoping to help friends who like cosplay.

Material: basic mask

-Hot glue gun and glue stick

-A small piece of yellow foam board

-Black belt

Scissors and scissors

Steps:

1. Stick a small piece of yellow foam board on the basic mask or your own mask with a high-temperature glue gun, and cut the foam board into the iconic "tooth" shape of Frank's mask with scissors.

2. Stick these "teeth" around the top of the mask with a glue gun. You can also wrap a few more wires to make the "teeth" stronger. At the same time, in order to prevent the rubber groove from overflowing, it is best to fix it from the outside of the car body.

3. Carve out the two ears in the middle of Frank's mask, and then make two big ears with yellow foam and stick them on the ears. Stick it on with a glue gun and a black belt according to your favorite angle.

4. Repair the "teeth" with a high-temperature glue gun again, and then apply yellow paint. Cover your eyes with black anti-secrecy.

5. After sticking it on the ear, cut the mask along the angle to give off a feeling of disgust.

6. After all the above parts are completed, fill the gap between "teeth" with white pigment bubbles, and spray a layer of transparent bright paint on the whole mask to increase the three-dimensional sense of the characters.

7. When the pigment on the mask is dry enough, you can put it on.

The above is the tutorial for making Frank Mask. I hope that friends who like it can refer to it and make their own Frank mask.