How does stainless steel pot shovel use silica gel to bond silica gel and stainless steel together? Do you have any good recommendations?

1. Silica gel and stainless steel are bonded, and the material surfaces of both products are relatively inert and not easy to stick. Dry glue and treatment agents, such as LOKBONDCA25 and 7387, are recommended for small areas, which can quickly achieve better bonding positioning strength; If the area is large, it can be bonded with silica gel. For example, LOKBOND638 silica gel can be combined with silica gel and metal. After bonding, it has good toughness and elasticity, strong peeling resistance and tensile strength, and is not as brittle as dry glue, that is, the curing time is slightly slower than dry glue, and one component does not need a treatment agent. Simple operation and low cost.

2. 1. Clean the stainless steel surface to ensure that it is clean and dry! (The purpose is to remove oil stains and rust spots on the surface of stainless steel)

2.2. Apply silica gel and special adhesive treatment agent for hot forming of stainless steel (also called metal primer, metal treatment agent and hot vulcanized rubber/liquid medicine) evenly on the cleaned stainless steel surface, or directly soak it; After treatment, it is naturally dried at room temperature 1 hour (if you want to be faster, you can bake it in an oven at 60 degrees for 20 minutes. Pay attention to the low baking temperature, not too high).

2.3. Put it into the mold together with glue stick material for compression molding! The molding temperature is higher than 65438 060 degrees (preferably not more than 200 degrees).