How do I remove the lower bobber from my old wave washer? I have loosened the screws. Thanks!

The solution to unscrew the screw in the center of the inner chassis of the automatic washing machine is:

1. Use a suitable Phillips screwdriver to loosen the screws of the center base, be careful not to use excessive force, as shown in the picture below.

2. After completely loosening the screws, carefully remove them by hand in order to take out the base directly, as shown in the picture below.

3. It is best to tilt the base slightly to select the position with the largest diameter in the washer drum, as shown in the picture below.

4. There is a lot of dirt in the inner tube of the removed base, which can be cleaned directly so that it is easy to remove, as shown in the picture below.

5. The removed base can be washed directly with running water. Wash carefully, must be cleaned on both sides, as shown in the following picture.

Expanded information:

(1) When selecting "Wash

(1) When selecting "Wash" or "Rinse" program, the wave wheel will not run until the selected water level is reached;

(2) During the dewatering program, the cover of the machine must be closed, and it is not advisable to open the cover from time to time,

(3) Never touch the washing and dewatering drum with your hands, so as not to involve your hands in danger;

(4) Never touch the washing drum with your hands, so as to avoid involving your hands in

(4) Never wash or dewater clothes containing volatile substances (solvents, alcohol, etc.) to avoid accidents;

(5) In the case of unbalanced dewatering, the computerized automatic washing machine is capable of correcting the unbalanced dewatering, and if the unbalanced problem is not solved after 2 corrections, the machine will be shut down and an alarm will be issued, at this time, the cover of the machine should be opened, and the clothes squeezed to one side should be put evenly, and then the cover should be closed. At this time, you should open the cover of the machine, put the clothes on one side, then close the cover of the machine and press the "start/pause" button.