How to use the heating stove

1, atmospheric boiler, it is forbidden to run under pressure, the boiler can be heated, bathed or watered with boiling water.

2. The diameter of the upper water pipe for installing the radiator shall not be less than 1.5 inch. The pipe diameter is too small, which affects the water output and backwater of the boiler. There is little backwater in the boiler, which is easy to boil and produce steam, which affects the water cycle.

3. Because the residual gas hidden in the boiler and heating pipe is high, an exhaust pipe should be installed at the top of the pipe leading to the radiator.

4. Regardless of several groups of radiators, after the hot water circulation starts, the radiators should be heated evenly. When the water circulates to a certain position, the hot water does not move forward, and there is a route circulation, indicating that there is more gas in the water supply pipe in the near section. Therefore, it is necessary to install a tee to release gas.

5. When the boiler is burning, close the fire door and open the ash door. When it is not burning, add coal to the ash door, and don't put out the fire.

6. Before using the drinking water boiler, boil water to clean the boiler, and discharge the sewage through the drainage pipe.

7. Remove the scale on the boiler in time (the scale thickness shall not exceed 2mm), so as to improve the thermal efficiency and prolong the service life.

8. When installing the safety valve (explosion-proof valve), pay attention to check the rubber gasket of the safety valve, and replace it in time if it is aging.

9. The shower is equipped with a three-way valve for cold, hot and mixed water to adjust the water temperature to avoid overheating and scalding. In any case, the water inlet or outlet of the shower should be connected with the atmosphere to prevent the heat exchanger from forming a closed container, and the water will expand when heated in the heat exchanger, causing the explosion of the heat exchanger.

10, remove the slag under the grate in time to prevent the grate from burning out.

1 1. Dust removal and maintenance should be carried out in the furnace after shutdown, and desiccant should be put in the furnace to prevent wet corrosion and shorten the service life. When the boiler stops in winter, it should be drained in time to prevent the boiler from freezing.