How to make a round ceiling of gypsum board

1, nail the base of wooden strips, and then cut the gypsum board.

2, after nailing the wooden strips, use a knife to cut the parchment layer on the back of the gypsum board, and then gently press the bend and stick it on the round material.

3, then the laying of wires, through the wooden frame will be used in the light strip wire around the entire ring outer circle.

4, Then measure the size of the empty portion underneath, cut plasterboard slightly smaller than this size and fix it to the wooden frame with a yard nail gun.

5, During the re-fixing process, the position of the round holes should be left roughly where they should be, and then the final plasterboard sealing and fixing should be carried out.

6, the last is to use a knife to excise along the circular dimension prior measurement mark, remove redundant plasterboard, shelving a circle, and then mixed with fine plasterboard wooden round hollow vertical stopper, light tape sealing gland as that is completed.