How to tie casting hooks

The casting rod fish hook tying method as shown:

1. fishing, should be placed into the rod bag fishing trip, if there is no rod bag is best to cast the rod cover in the rod tip, so as to avoid cycling or riding in the car was accidentally impacted, so that the rod tip broken and can not be used.

2. When fishing, you should first install the fishing line wheel on the pole fixed, fixed line wheel screws should be tightened one by one, not at the same time, so as to avoid screws slippery teeth, and then properly release a section of the line (slightly longer than the casting rod) will be the fishing line in turn through the line ring, the right hand to grab the rod body (the fish wheel on the location of the point), the left hand to grab the tip of the rod, in order to draw out the rod can be slightly twisted after the combination of casting rod, feel the interface of the rod without gaps. The rod's interface without gap can be. Do not pull too tight, nor too loose. Too loose the rod will suddenly slip, too tight to collect the rod is difficult. The rod should be recovered from the thick section to the details (tip direction) in an orderly manner. When it is difficult to collect the rod, you can grab the upper and lower sections and twist them together, do not use the thick section to hit the previous section, so as not to top off the magnetic ring of the previous section.

3. When you are ready to cast, you should look back and pay attention to the fishing space to see if there is enough room for the rod length, especially in the environment with tree branches, so as not to scrape the rod tip when casting. When setting up the rod, it should be placed lightly so that the rod body and the magnetic ring are not subjected to violent impact, resulting in the rod body cracking casting rod fishing methods, magnetic ring falling off, deformation.

4. In crowded places, it is better to put the casting rod holder higher to prevent others from stepping on it unintentionally. In the fishing grounds where there are more big fish, the rod should also be fixed to prevent big fish from dragging the rod away. When you are hooking a big fish, don't raise the pole violently, so that the pole body can't withstand the momentary tension and break the pole, when there is a bottom, you should firstly set the pole flat (not make the pole weight) with the elbow wrapped around the fishing line, pull off the bottom of the fishing group, do not pick the method to get rid of the bottom of the fierce tugging.