How to make a full placket cheongsam with split ends

How to make a full placket cheongsam is as follows:

You need to prepare the following tools and materials: scissors, needle and thread, drawing powder, paper pattern, lining, interlining, and belt. The production steps are as follows: first, put the paper pattern on the fabric, according to the size of the front piece, back piece, placket, sleeve piece, collar piece, side seam line with drawing powder.

Next, cut the fabric separately and sew the fabric together with a large needle, leaving the cuffs, hem and center back piece seams. Then sew the front and back piece side seams together and sew the placket and collar together. Cut and sew the lining, pull the lining and facing fabric flat, facing each other, and sew the collar and cuffs. Finally, turn the dress inside out and iron it flat to finish the production.

It is important to keep the process clean and hygienic to avoid contamination and bacteria during the making process. In addition, it is important to pay attention to details during the production process to ensure that each step is fine and perfect.

Sewing method of cheongsam opening:

Folding material: first fold both sides of the fabric edge face inward, the left side of the left side of the reserved sticker edge of 3 centimeters, and then according to the length of the garment dimensions + 2 centimeters to draw a line of the garment length, i.e., folding the shoulder line.

Biased flap: bias the left and right ends of the top layer of fabric (even the edge of the folded shoulder line) downward by 2.5 centimeters to move the top layer of fabric downward, so that the top layer at the bottom ends of the bottom edge is about 5 centimeters more than the bottom layer of fabric, while the top layer of fabric at the bottom edge of the folded shoulder line is about 2.5 centimeters more than the bottom layer of fabric.

Shoulder folding: Fold the fabric from the shoulder fold line to the lower layer according to the length measurement + 2 cm, which makes 4 layers. The top two layers are for the front body and the bottom two layers are for the back body. At the straight edge of the folded shoulder line, the inner layer should be set back 2 centimeters from the outer layer in order to have enough for the inside placket, which can be further increased by the placket.

Setting up the province: first measure 6--8 centimeters from the underarms, the province is 3 centimeters, see point A. And then from the neckline deep line to the bust line to take the center point as the provincial road slope line position, folding amount of 1 cm, see point B. Draw two oblique straight lines, and then pinch up the upper edge of a downward fold, point A double layer of 1.5 centimeters, point B double layer of 0.5 centimeters.