Adjustment method and key points of dead spindle ring of spinning frame

The methods and key points for adjusting the dead spindle rims of spinning frames are as follows:

1, the traditional straight line correction method-knocking on the spindle (some machines are steel collars) and hanging wire hammer, which is time-consuming and laborious and has poor effect. (2) The new calibration method with three concentric calibrators is convenient, fast and accurate, which is worth popularizing.

2. Use the traditional linear tri-concentric correction method to correct the spindle and ring. Before knocking the spindle coaxially, the ring plate must be corrected: the lifting position of the ring plate relative to the spindle is always in a straight line, and the ring plate of the whole vehicle is on the same horizontal plane. The steel collar must be fastened and must not be loose or skewed. The lifting of the collar plate should be flexible, without vibration, jamming and other problems.