Fireplace insert installation method, fireplace insert precautions

For every family fireplace is also a modern popularity, with the improvement of conditions, almost no stranger to the fireplace, but in the purchase of the time can not help but also encounter a lot of problems, it does not matter that we can first understand the relevant knowledge in advance, so that in the utilization of the time will not be caught off guard, now let me introduce you to the fireplace core relevant information about the fireplace. strong>Related information about it.

A, fireplace core installation

1, real fireplace fireplace to lay a good stone base before installation. If not stone, to do a good job of insulation and waterproofing, fire treatment. The height is set at about 150mm.

2, with a chimney: for villas with chimneys, detached self-built houses, the general smoke pipe is only about 3-4 meters, and then lead the pipe to the chimney.

3, without chimney: there is no chimney for the installation of wood-burning fireplaces in the house, you can use the pipe to discharge exhaust gas, the requirements of its specifications: 4 meters ≤ pipe height ≤ 15 meters, that is, the height of the pipe can not be less than a minimum of 4 meters, at most, not more than 15 meters, and the highest should be more than the roof of 1 meter. (In case of special circumstances should be handled separately)

4, the direction of the pipe can be selected according to the structure of the house to go to the outside wall or go to the inside wall installation. If you don't want to wear the floor, you can choose to wear the pipe from the back of the fireplace out of the wall, along the exterior wall wall straight to the roof 1 meter.

5, to install a new fireplace, it is best to decide the best installation location based on the interior of the house. More suitable installation location is the living room, bedroom and kitchen these places. There are generally three forms of its installation location: one in the dividing wall right in the center.

6, another in the outer wall and the inner wall right at the foot of the shade, the room behind these two, must be close to the partition wall of another fireplace, they *** with the same flue; the third is in the hall in a prominent position independent of the upper and lower fireplaces are generally aligned.

7, the upper part of the fireplace smoke column has a few small holes to the room, these small holes are set up to use the fireplace flue exhaust indoor. For cast iron fireplace, each model has different installation requirements.

8, carefully check the location of the need to change before deciding on the product model, you will get twice the result with half the effort. In general, the simplest installation than the installation of a flue-free fireplace, it just need to smoke pipe through the wall or floor and machine connection on the line.

Two, the fireplace core notes

1, the annual use of the wall-hung boiler, it is necessary to check the ventilation system of the wall-hung boiler, effectively preventing the wall-hung boiler ventilation system in the blockage and damage.

2, the wall-hung boiler in operation, the bottom of the wall-hung boiler heating, wall-hung boiler hot water outlet pipe and wall-hung pipe temperature is relatively high, so in the use of the time must be strictly prohibited from touching, to effectively avoid scalding. Also if you want to dismantle the wall-hung boiler, try to choose a professional, so as to avoid causing accidents caused by poor sealing of the pipe interface.

3, the fireplace can not be modified, after the repair of the fireplace components to be used before all installed in place, the installation and maintenance of the fireplace must be carried out by professionals. Need to check once a year.

4, the user in the decoration of the closed balcony or move the machine, the smoke pipe must be suction, exhaust out of the window, shall not be sealed indoors or the use of single-core pipe, or the wall-hung boiler in the combustion of exhaust gases easily sucked back, resulting in combustion of oxygen supply is insufficient, will easily lead to the wall-hung boiler deflagration, can not ignite the fire, or frequent start-up phenomena, to the safety of life and property to leave a hidden danger.

5, the fireplace to keep clean, and away from gas and other combustible gases or liquids. After setting up the anti-freeze function, it is necessary to ensure that the water, electricity and gas in the home is sufficient and unobstructed. As a precautionary measure, the water pressure and working condition of the fireplace should be checked regularly after the anti-freeze is set to make sure that it is safe.

The above introduction to the editorial about the fireplace insert installation and fireplace insert notes, I hope that this information, can let the majority of friends get more help, thank you for the majority of readers to read, well the introduction ends here.