Toilet waterer disassembly and installation

Toilet waterer removal and installation steps are as follows: Removal: 1. Close the water source valve, the water pipe on the water drain. 2. Remove the fixing screws of the waterer, usually at the bottom or side of the tank. 3. Remove the waterer from the tank, pay attention to do not damage the internal parts of the tank. 4. Installation: 1. Place the new water dispenser on the tank and tighten the fixing screws. 2. Connect the water pipe to the water dispenser, taking care to seal it with a sealing gasket or sealing tape. 3. Open the valve of the water source and check whether the water dispenser is leaking or not. 4. Test whether the toilet flushes normally or not, and if there is any abnormality, it is necessary to re-check the installation to see whether the installation is correct. Note: 1. In the process of disassembly and installation, be careful not to damage the internal parts of the water tank. 2. When installing the water dispenser, pay attention to the tightness of the fixing screws, too tight or too loose will affect the use of the toilet. 3. When connecting the water pipe, pay attention to the use of sealing gaskets or sealing tape for sealing, so as to avoid leakage of water. 4. After the completion of the installation, make sure to test the toilet flush is normal to ensure that the installation is correct.