Teaching of traditional headlamp system

Instructions for use of modern eastern Guangdong lighting

1. Turn signal and stop light

The light can only be turned on after the vehicle is ignited. The way to open it is simple. You just need to turn the button on the light pole to turn on the corresponding light.

① Use of left turn signal: Turn down the light lever and turn on the left turn signal.

② Use of right turn signal: Turn the light control lever upward and turn on the right turn signal.

If you don't pass the resistance point, gently lift or press it, the side turn signal flashes three times and then goes out.

2. High beam and instantaneous opening function of high beam

Move the joystick to the corresponding position:

③ Use of high beam: Just press the light control lever to turn on the high beam.

④ Instantaneous turn-on function of high beam: After turning on the headlights, it is a good warning means to pull back the lamp pole to activate the alternation of far and near beams.

In the instrument cluster, you can see that the high beam symbol lights up.

The fog lights are on.

The fog light switch knob is located in the center of the light operating lever, and it only needs to be rotated/toggled to the corresponding position when it is turned on.

4. Automatic headlights (only available in some cars), low beam lights and width indicator lights.

When the control lever is turned to the AUTO position, it means that the automatic headlights are turned on. Turn the knob to switch to width indicator, automatic headlight and low beam.

5. Headlight cleaning (only applicable to some cars)

As long as the headlights are turned on, the glass water switch will be turned on at this time, and the headlights will be sprayed while spraying glass. If you only want to clean the glass and don't want to clean the headlights, then turn off the headlights.

6. Adaptive headlights (only applicable to some cars)

On mode: When the light is in the automatic position, push the light pole forward to turn on the light.

① Adaptive headlights can adjust the height of headlights according to the turning angle and vehicle speed. When the steering angle exceeds a certain value and the turn signal is turned on, the adaptive headlights will be turned on automatically. The vehicle speed must not be higher than 70km/h, otherwise the adaptive headlamp system cannot be accurately identified and turned on.

② Some high-end models will also be equipped with light intensity sensors. When the sensors recognize the light of the opposite vehicle, they will automatically switch the high beam to the low beam.

@20 19