Steps for Fishing Line Tying

Super-detailed fishing main line tying illustrated tutorials, learn never have to buy a finished line set

First of all, you need to prepare the rod (main line target length rod), fishing line, space beans, drift seat, lead seat, 8-ring, as shown in the figure below:

Take out a section of the main line folded in half, and then from the red space beans (lock the rod slightly with the steel wire aerial through the wire, as shown in the figure below:

Move the red space bean from the wire, and put it on the folded wire, as shown in the picture below:

Tie a knot on the top and bottom of the space bean, about 5-10cm between the 2 knots, and keep about 1cm between the top knot and the retained coil at the top, as shown in the picture below:

In the middle of the space bean and the knot on the top wire, tie a horseshoe knot, and put the pole pole string out of the horseshoe knot, and tighten the knot. Then tighten the horseshoe knot, move up the space bean, and fix it, as shown in the picture below:

Take out the rod section by section, measure the length of the main line, and let the line go beyond the body of the rod by 20-30cm when the rod is kept straight to facilitate the installation of the fittings, as shown in the picture below:

Install 2 space beans first, and put the threads out of the air from the wire ropes of the space beans, and then move up the space beans to the main line.

Then install the float seat, the hole of the float seat is bigger, directly put the thread out of the hole at the bottom of the float seat, as shown in the picture below:

And then install the 4 space beans, the installation method is the same as above, and I won't go into details later, as shown in the picture below:

Install the lead holder, the hole in the holder is bigger, directly put the thread out of the center of the holder, as shown in the picture below:

Install the lead holder, the hole in the holder is bigger, directly put the thread out of the center of the holder, as shown in the picture below

And then put the last space bean on, as shown in the following picture:

Finally tied on the 8-ring (8-ring binding method has many kinds, the previous video has a tutorial for the 8-ring binding method, here will not be introduced), and then cut off the excess thread can be, as shown in the following picture:

Therefore, the mainline line fishing thread binding is complete, learn the small partners! Help point a concern, forwarding, do not understand can follow the light soaring, watch the previous release of the main line tying tutorials, if there are deficiencies, welcome to leave a message to correct.